• MultiCyclone pre-filters up to 80% of the filter’s incoming dirt load easing the workload of the swimming pool filter. As the MultiCyclone intercepts more and more dirt, the flow rate remains unchanged.

    • Improving pool water circulation

    • Enhancing the performance of the automatic pool cleaner and in-floor cleaning system

    • Allowing effective pool vacuuming without burdening the pool filter

    • Minimising filter maintenance and saving water

    Minimise backwash frequency

    The installation of a MultiCyclone as a pre-filter to a sand filter can reduce its backwash frequency to once per year, resulting in a saving of up to 7,000 litres of water per year for an average domestic sized swimming pool.

    Minimise cartridge cleaning and replacement

    The installation of a MultiCyclone as a pre-filter to a cartridge filter can reduce filter cartridge cleaning and replacement to once per swimming season and even up to once per year, depending on the size of the cartridge filter.

    • Minimises filter maintenance and saves water

    • No filter media to clean or replace

    • Suitable for new and existing installations


  • A 50mm main drain is installed in the deepest part of a swimming pool and is connected to the pool's circulation system. Its purpose is to draw water from the bottom of the pool, helping improve water circulation, filtration efficiency, and chemical distribution. The main drain works alongside the skimmer to remove debris and prevent stagnant water areas. It also assists when vacuuming the pool and can help lower the water level when required. A properly functioning 50mm main drain contributes to cleaner, clearer water and more efficient operation of the pool equipment.

  • A dual port 50mm skimmer is installed at the waterline of a swimming pool and is designed to remove floating debris such as leaves, insects, and dirt before they sink to the bottom. The skimmer draws surface water through a basket that collects debris, helping maintain clean and clear water.

    The primary 50mm port is connected to the pool's filtration system, while the second 50mm port can be used to supply water to a water feature or an additional in-floor cleaning system. This allows greater flexibility in pool design and hydraulic performance while maintaining efficient surface skimming. By continuously removing debris and circulating water, a dual port skimmer helps improve filtration efficiency, water clarity, and overall pool health.


  • The 50mm Blue Square In-Floor Module is the control centre of an in-floor cleaning system. Water is supplied from the filtration system into the module, where an internal valve assembly automatically rotates and directs water flow to different cleaning zones throughout the pool. As each zone is activated, high-pressure in-floor cleaning heads pop up and spray water across the pool floor and walls, pushing debris toward the main drain or collection point.